Re-sanding Old Floors

Re-sanding Old Floors

Re-sanding Old Floors

If you have old hardwood timber flooring in Melbourne, it’s handy to know how to re-sand and finish your recycled timber flooring Melbourne. Here’s what you need to know about DIY re-sanding and what to consider when you undergo timber flooring installations Melbourne.

Safety First

The first step is to make sure you use safety goggles when re-sanding engineered timber flooring Melbourne. You should also wear a dust mask, earplugs and sturdy shoes to protect your feet. There should be proper ventilation in the room including opening the windows and switching on a box fan.

The Four Main Tools

There are four particular tools to consider budgeting for when sourcing hardwood flooring prices Melbourne. These are an orbital sander, a drum sander, a palm sander and also an edge sander. You don’t have to buy them though; you can rent the tools for the day.

Sandpaper for Timber Flooring Repairs Melbourne

Sandpaper is cost-effect, so make sure you buy loads of it. Choose 30-grit, 60-grit and 100-grit; and if you’re keen on elbow grease, even get some 150 grit. The bigger the grit rating of the sandpaper, the finer the finish you will achieve. The different sanders call for different shapes and sizes of sandpaper, so make sure you get the right paper.

Start in Reverse

Hardwood timber flooring in Melbourne requires upkeep, and if you’re going to re-sand, the best place to start is in reverse. Start with the palm sander, followed by an edger and then an orbital sander. This process makes it easier to cover up any mistakes you make.

Begin with the palm sander and 30-grit sandpaper and start off sanding out the corners. Sand them to a radius of eight inches and get right down to the bare wood. Change to 60-grit paper and repeat. Beware that the 60-grit paper will wear off faster. Finish off with the 100-grit, and you’ll be able to admire a seriously smooth finish!

The Next Step

When looking at timber flooring prices, do budget for the rental of sanders and edgers. The next step is to hire an edger for a couple of hours. There are a multitude of online videos that will talk you through how to properly use them. Begin with the 30-grit paper and again sand down to a bare wood within a foot of the room’s edge. At this stage you can overlap the areas that you’ve already done with the palm sander. Move on to 60-grit and finish with 100-grit sandpaper.

The Final Step

Use an orbital sander to finish your floors with. Repeat the process of 30 – 60 – 100 grit over the entire surface and overlap the areas you have already done.

Re-sanding Old Floors

Once you’re done, there should not be any gouges and the surface of the floors will be ultra-smooth. That’s when it’s time to apply a sealer.

Is Floor Sanding a Lengthy Process?

On average, a 10-by-12 foot room will take about fourteen hours of good, hard work to re-sand! But you don’t have to do it all in one go, you can break it up over a couple of days.

The palm sanding is probably the quickest part and only takes a few hours, some of which is spent getting the ventilation right and setting up the equipment. The edging also goes fairly quickly but the machine does tend to gum up with pain. So don’t be stingy with the sandpaper!

The orbital sanding probably takes the longest for hardwood timber flooring in Melbourne. Break this up over a few days and have plenty of patience. You don’t want to rush the re-finishing process or cut corners.

There Will Be Imperfections!

Accept it, you’re not a professional floor re-sander! So there are going to be a few rough spots. If you want your floors to be, well, flawless, hire a professional. But even as a first-time re-sander, you can do a great job with the right tools and plenty of patience. In no time your old hardwood floors could be as shiny and fresh as if they were brand new.


Leave a Reply