Bathroom Floor

Bathroom Floor

Laying the mortar bed or topping to a bathroom floor

Preparing The Old bathroom Floor For The New Cement Topping, Scabbling

After the touch up plastering the next job was to clean up the floor and lay a bed of sand and cement topping. A quick scrape around with a shovel removed most of the rubbish on the floor and it was looking quite clean. Of course this quite clean floor was what the existing topping was laid on, and that one was drummy, it was not bonded properly. I needed to scabble the floor. That is to get the old floor into a state where the new sand and cement topping will bond onto it.

  • If I had no power tools on hand to do the job, I could have gone to the hire shop and got what is called a floor scabbler to do the job. Usually air driven (so you need to hire a compressor also), they consist of a few rotating jack hammer/rock drill type heads on a carriage. They are great for scabbling large floors, but a bit of overkill for a small bathroom.
  • There are a few other air operated tools that would do the job, like the hand held bush hammers or needle scabblers, but I had my own tools that could do the job.
  • I could have chipped away all over the old surface with a chisel bit in my rotary hammer drill. Tedious but effective.
  • Or the option that I chose, which was grind away the surface slightly with my large angle grinder with a diamond cup disk in it.
  • Another way is to acid etch the bathroom floor. That is to use diluted Hydrochloric acid (Muriatic acid) on the old surface, to eat away the surface of the cement and contaminants. This would have been very easy, but I am always a bit wary of using acid indoors, especially in a bathroom with poor ventilation. If you acid etch concrete you need plenty of water handy to rinse the residue away.

Those are a few ways of providing a mechanical key. Of roughening up the surface so that the new concrete, or cement mortar in this case, can bond onto the old concrete.

In addition to to roughening up the surface, the bond between the old and new can then be increased by using the so called chemical keys. I’ll be dong this as well, because the topping will be quite thin, going down to about 8mm only at the floor waste.

  • The one I am using here has already been described, using Bondcrete as a primer and also in the cement mix.
  • Another excellent way of bonding old to new concrete is by using epoxy. I have done quite technical jobs where we poured the new concrete onto the old, using an epoxy that was hydrophillic (water compatible). The old concrete was coated with the epoxy and then the new was poured while the epoxy was still wet.Of course this was in a critical application, hardly a residential bathroom.

So after checking that the floor waste still had a plug of towel in it to catch debris; I bit the bullet, put on my ear muffs, dust mask and visor and gave the floor a good run over with the diamond grinder.

Cement Topping, Falls To Floor Waste

  • I decided to use only a 20mm fall from a level line all around the walls down to nothing at the 100mm floor waste. The bathroom is so small that the 20mm is plenty. The floor was level all around, so all I had to do was make the topping an even 20mm at the the walls and door, falling to nothing at the waste.
  • Once again I used my Bondcrete primer, and Bondcrete enriched sand and cement mix for the topping.
  • I used my own «make it easy for me» method that any of my tiling or plastering mates would surely laugh at if they saw how I was doing it. Definitely not fast and good like they do. More like slow and rough, but I was happy with the end result.


Leave a Reply